Use these procedures to troubleshoot the CXPI communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the power integration system is functioning normally.
| Result | Proceed to |
|---|---|
| Power integration system DTCs are not output | A |
| Power integration system DTCs are output | B |
A
B
Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Data List / Active Test
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT