Home › Power Source / Network › POWER DISTRIBUTION › POWER INTEGRATION SYSTEM
RM37H0E _57 Power Source / Network _095301 POWER DISTRIBUTION _0455449 POWER INTEGRATION SYSTEM Y

POWER DISTRIBUTION  POWER INTEGRATION SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the power integration system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT AUXILIARY BATTERY VOLTAGE
2.INSPECT AUXILIARY BATTERY VOLTAGE
a.

Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.


Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CXPI COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF CXPI COMMUNICATION SYSTEM*
a.

Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.


Result:
Proceed to
No DTCs output
DTCs output



No DTCs output

4.CHECK FOR DTC*

DTCs output

4.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.


b.

Clear the DTCs.

i.

No. 1 semiconductor power integration ECU (w/ PTC Heater)

Body Electrical > Power Integration No.1 > Clear DTCs
50002 410

ii.

No. 2 semiconductor power integration ECU

Body Electrical > Power Integration No.3 > Clear DTCs
50002 412


c.

Recheck for DTCs.

i.

No. 1 semiconductor power integration ECU (w/ PTC Heater)

Body Electrical > Power Integration No.1 > Trouble Codes
50001 410

ii.

No. 2 semiconductor power integration ECU

Body Electrical > Power Integration No.3 > Trouble Codes
50001 412


Result:
Proceed to
No DTCs output
DTCs output



No DTCs output

5.PROBLEM SYMPTOMS TABLE

DTCs output

5.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table



Fault is not listed in problem symptoms table

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

Fault is listed in problem symptoms table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

END