Home › Brake › PARKING BRAKE › PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455457 PARKING BRAKE SYSTEM L

PARKING BRAKE  PARKING BRAKE SYSTEM  PRECAUTION  


NOTICE:
·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed with the door courtesy switch on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the auxiliary battery is connected.

·

Do not operate the electric parking brake switch with the auxiliary battery connected, unless otherwise instructed in the procedures.

·

Make sure that the electric parking brake AUTO function is off. This is necessary to prevent the system from activating when the shift position is moved.

·

Before disconnecting the auxiliary battery cable or other connectors, prevent DTCs from being output by following the procedures below.

-

Turn off the electric parking brake AUTO function.

-

Press the parking switch with the ignition switch turned on (IG) to activate the parking lock.

-

Operate the electric parking brake switch assembly to release the parking brake.

-

Turn the ignition switch off.

-

Do not operate the parking brake.

-

Wait 30 seconds or more.


·

After replacing or inspecting the parking brake shoe or rear disc, perform parking brake bedding.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>UTILITY

·

When servicing the brake system, make sure its parts and surrounding parts are clean.



RELEASE PARKING BRAKE


a.

With the ignition switch on (IG), operate the electric parking brake switch to release the parking brake. Then turn the ignition switch off.

HINT:

If the parking brake cannot be released, follow the procedures when using SST to release the parking brake.

Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD




PRECAUTIONS WHEN WORKING ON VEHICLE


a.

When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force may not be sufficient. Make sure to pull the electric parking brake switch assembly to the lock side 2 times (2 lock operations).

HINT:
·

The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag ECU assembly).

·

When the parking brake indicator is illuminated after the electric parking brake switch assembly has been pulled to the lock side, the maximum amount of braking force is applied if the electric parking brake switch assembly is pulled to the lock side one more time.





PRECAUTIONS FOR TOWING VEHICLES


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION