0,0 0,0
false
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with union nut wrench |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
48630D
1.INSTALL FRONT UPPER NO. 1 SUSPENSION ARM ASSEMBLY LH
| *a | 4.84° | *b | 40.1 mm (1.58 in.) |
| *c | 215.3 mm (8.48 in.) | - | - |
Temporarily install the front upper No. 1 suspension arm assembly LH to the front upper No. 1 arm bracket LH with the bolt and nut.
When installing the front upper No. 1 suspension arm assembly LH, temporarily tighten the bolts at the position shown in the illustration.
Fully tighten the bolt.
48630E
2.INSTALL FRONT UPPER NO. 2 SUSPENSION ARM ASSEMBLY LH
| *a | 7.34° | *b | 30.8 mm (1.21 in.) |
| *c | 210.7 mm (8.30 in.) | - | - |
Temporarily install the front upper No. 2 suspension arm assembly LH to the front upper No. 2 arm bracket LH with the bolt and nut.
When installing the front upper No. 2 suspension arm assembly LH, temporarily tighten the bolts at the position shown in the illustration.
Fully tighten the bolt.
48657C
3.INSTALL FRONT UPPER NO. 1 ARM BRACKET LH
| *a | Torque Wrench Fulcrum Length | - | - |
Install the front upper No. 1 arm bracket LH with the 2 bolts (A).
Using a 14 mm union nut wrench,, install the bolt (B).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 35.1 N*m (358 kgf*cm, 26 ft.*lbf)
48658B
4.INSTALL FRONT UPPER NO. 2 ARM BRACKET LH
| *a | Torque Wrench Fulcrum Length | - | - |
Install the front upper No. 2 arm bracket LH with the 2 bolts (A).
Using a 14 mm union nut wrench,, install the bolt (B).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 35.1 N*m (358 kgf*cm, 26 ft.*lbf)
43212
5.CONNECT STEERING KNUCKLE LH
Install the steering knuckle assembly LH to the front upper No. 1 suspension arm assembly LH and front upper No. 2 suspension arm assembly LH with the 2 nuts.
Install 2 new clips.
Further tighten the nut up to 60° if the holes for the clip are not aligned.
6.INSTALL FRONT WHEEL
7.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
8.PERFORM INITIALIZATION