| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT LOWER BALL JOINT ASSEMBLY | 43340A | ( )
|
- | - |
| 2 | LOWER NO.2 SUSPENSION ARM ASSEMBLY LH | 48670 | ( )
|
- | - |
| 3 | STEERING KNUCKLE LH | 43212 | - | - | - |
0,0 0,0
false
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
43340A
1.INSTALL FRONT LOWER BALL JOINT ASSEMBLY
Install the front lower ball joint assembly LH to the front lower suspension arm assembly LH with the nut.
Keep the threads and taper free of oil and grease.
Install a new clip.
Further tighten the nut up to 60° if the holes for the clip are not aligned.
43212
3.INSTALL STEERING KNUCKLE LH