| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT WHEEL | - | - | - | - |
| 2 | FRONT COMPARTMENT UNDER COVER | 51441N | - | - | - |
| 3 | FRONT LOWER SUSPENSION MEMBER PROTECTOR | 51219 | - | - | - |
| 4 | FRONT COMPARTMEMT UNDER COVER ASSEMBLY | 51420A | - | - | - |
| ● | Non-reusable part | ★ | Precoated part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | FRONT STABILIZER LINK ASSEMBLY LH | 48810 | ( )
|
- | - |
| 6 | FRONT STABILIZER LINK ASSEMBLY RH | 48820B | - | - | - |
| 7 | FRONT STABILIZER BAR | 48811 | ( )
|
- | - |
1.REMOVE FRONT WHEEL
51441N
2.INSTALL FRONT COMPARTMENT UNDER COVER
51219
3.REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR
51420A
4.REMOVE FRONT COMPARTMEMT UNDER COVER ASSEMBLY
48810
5.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and front stabilizer link assembly LH.
If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.
48820B
6.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48811
7.REMOVE FRONT STABILIZER BAR
Remove the 4 bolts and front stabilizer bar.
The stabilizer bracket and bush are built onto the stabilizer bar.
If the bracket and/or bush detach from the bar, replace the bar.