Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C0  Front Right Seat Heat Sensor Circuit  


DESCRIPTION

Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C0 Front Right Seat Heat Sensor Circuit Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Front seat cushion heater assembly RH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396781E14
1.115,2.104 2.677,2.677 1.563,0.573 10 false Air Conditioning Amplifier Assembly 2.292,0.948 2.667,1.188 0.375,0.24 10 false TSR 2.229,1.5 2.75,1.76 0.521,0.26 10 false SG-7 1.115,1.917 1.5,2.177 0.385,0.26 10 false D78 2.656,0.844 3.063,1.156 0.406,0.313 10 false 12 2.688,1.375 3.031,1.823 0.344,0.448 10 false 3 4.354,2.125 6,2.698 1.646,0.573 10 false Front Seat Cushion Heater Assembly RH 4.365,1.948 4.719,2.229 0.354,0.281 10 false L10 4.313,0.833 4.5,1.052 0.188,0.219 10 false 4 4.281,1.365 4.583,1.615 0.302,0.25 10 false 5

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C0 is not output A
B14C0 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY RH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY RH)

Pre-procedure1

a.

Disconnect the D78 air conditioning amplifier assembly connector.


b.

Disconnect the L10 front seat cushion heater assembly RH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D78,L10)Location & Routing

Click Connector(D78)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(L10)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly RH

D78-12 (TSR) - L10-4 Always Below 1 Ω
D78-12 (TSR) or L10-4 - Body ground Always 10 kΩ or higher
D78-3 (SG-7) - L10-5 Always Below 1 Ω
D78-3 (SG-7) or L10-5 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH

OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY RH