| *A | for Driver Side | *B | for Front Passenger Side |
| *A | for Front Passenger Side | - | - |
| *1 | SEPARATE TYPE FRONT SEAT CUSHION PAD LH | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat cushion heater removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH
87510L
14.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
Remove the tape and front cushion heater assembly LH.
Do not reuse the front cushion heater assembly LH.
If the front cushion heater assembly LH is removed from the separate type front seatcushion pad LH, replace the separate type front seat cushion pad LH with new one.