Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C1  Front Left Seat Heat Sensor Circuit  


DESCRIPTION

Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C1 Front Left Seat Heat Sensor Circuit Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Front seat cushion heater assembly LH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396781E15
1.115,2.125 2.656,2.615 1.542,0.49 10 false Air Conditioning Amplifier Assembly 4.385,2.115 6.063,2.646 1.677,0.531 10 false Front Seat Cushion Heater Assembly LH 2.313,0.958 2.594,1.104 0.281,0.146 10 false TSL 2.219,1.49 2.667,1.698 0.448,0.208 10 false SG-7 2.667,0.854 2.979,1.042 0.313,0.188 10 false 13 4.323,0.854 4.448,1.021 0.125,0.167 10 false 4 4.406,1.948 4.823,2.188 0.417,0.24 10 false L35 1.135,1.938 1.49,2.135 0.354,0.198 10 false D78 2.688,1.375 2.958,1.552 0.271,0.177 10 false 3 4.313,1.375 4.438,1.542 0.125,0.167 10 false 5

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C1 is not output A
B14C1 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY LH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY LH)

Pre-procedure1

a.

Disconnect the D78 air conditioning amplifier assembly connectors.


b.

Disconnect the L35 front seat cushion heater assembly LH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D78,L35)Location & Routing

Click Connector(D78)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(L35)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly LH

D78-13 (TSL) - L35-4 Always Below 1 Ω
D78-13 (TSL) or L35-4 - Body ground Always 10 kΩ or higher
D78-3 (SG-7) - L35-5 Always Below 1 Ω
D78-3 (SG-7) or L35-5 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH

OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY LH