| *A | for LHD | - | - |
| *1 | EV CONTROL ECU | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *A | for RHD | - | - |
| *1 | EV CONTROL ECU | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
89988D
1.INSTALL NO. 2 EV CONTROL ECU BRACKET (for LHD)
896B7
2.INSTALL NO. 1 EV CONTROL ECU BRACKET
3.INSTALL EV CONTROL ECU WITH EV CONTROL ECU BRACKET
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
5.INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU (for LHD)
6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
7. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8. ECU DATA WRITE
|
|
ECU data write
This function writes the ion exchanger maintenance distance data saved to the GTS to the EV control ECU.
According to the display on the GTS, write the ion exchanger maintenance distance data to the EV control ECU.
| Tester Display |
|---|
| ECU Data Write |
If the data is not written to the EV control ECU normally, perform the ion exchanger maintenance distance settings.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>INSTALLATION
9. ION EXCHANGER MAINTENANCE DISTANCE SETTING
|
|
Ion exchanger maintenance distance setting
According to the display on the GTS, perform the ion exchanger maintenance distance settings.
| Tester Display |
|---|
| Ion Exchanger Maintenance Distance Setting |
Correct ion exchanger maintenance distance input method
1. Input the cumulative distance on the meter
2. Input in units of 100 km
3. The input range is from 10000 km to 6553500 km
If the error screen is not displayed, turn the ignition switch off and wait for 10 seconds. Then, turn the ignition switch on (IG) and perform the correct ion exchanger maintenance distance settings again according to the display on the GTS.
10. UPDATE ECU SECURITY KEY