G9508
1.INSPECT EV SUPPLY STACK SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Pre-procedure1
Remove the EV supply stack sub-assembly.
Procedure1
Inspect the EV supply stack sub-assembly.
Check that no electrolyte is leaking from the No. 1 EV supply stack sub-assembly or No. 2 EV supply stack sub-assembly.
| *1 | No. 1 EV Supply Stack Sub-assembly | *2 | No. 2 EV Supply Stack Sub-assembly |
| *a | Check Part | - | - |
There is no electrolyte leaking from the EV supply stack sub-assembly.
If the result is not as specified, replace the No. 1 EV supply stack sub-assembly or No. 2 EV supply stack sub-assembly.
Post-procedure1
Install the EV supply stack sub-assembly.