Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C054016  Brake Pressure Sensor "A" Circuit Voltage Below Threshold  C05401F  Brake Pressure Sensor "A" Circuit Intermittent  C054029  Brake Pressure Sensor "A" Signal Invalid  C054031  Brake Pressure Sensor "A" No Signal  C054096  Brake Pressure Sensor "A" Component Internal Failure  C122D16  Brake Pressure Sensor "A" Supply Voltage Circuit Voltage Below Threshold  C122D17  Brake Pressure Sensor "A" Supply Voltage Circuit Voltage Above Threshold  


DESCRIPTION

HINT:

Brake pressure sensor "A": Master cylinder pressure sensor


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C054016 Brake Pressure Sensor "A" Circuit Voltage Below Threshold Master cylinder pressure value is below -0.744 MPa (-7.6 kgf/cm2, -107 psi) for 5 seconds or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C05401F Brake Pressure Sensor "A" Circuit Intermittent Fluctuation of the sensor signal exceeds the threshold (15 MPa (153.0 kgf/cm2, 2175 psi) or more from the previous value) for 0.1 seconds or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C054029 Brake Pressure Sensor "A" Signal Invalid Data from the sensor is invalid for 0.2 seconds or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C054031 Brake Pressure Sensor "A" No Signal Communication with the sensor is invalid for 0.1 seconds or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C054096 Brake Pressure Sensor "A" Component Internal Failure A malfunction is detected by self-diagnosis function of the sensor. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C122D16 Brake Pressure Sensor "A" Supply Voltage Circuit Voltage Below Threshold The supplied voltage to the sensor is less than a certain value for 1 second or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C122D17 Brake Pressure Sensor "A" Supply Voltage Circuit Voltage Above Threshold The supplied voltage to the sensor is a certain value or more for 1 second or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY

NEXT

END