Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C141C49  Brake Booster Motor "A" Control Internal Electronic Failure  


DESCRIPTION

Refer to DTC C059400.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C059400

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C141C49 Brake Booster Motor "A" Control Internal Electronic Failure Either of the following is detected:
·

When the voltage at terminal +BI1 is between 7.3 and 16.6 V, overcurrent is detected in the motor relay for 0.054 seconds or more.

·

Overcurrent is detected in the motor fail-safe relay for 0.054 seconds or more.


No. 1 skid control ECU (brake booster with master cylinder assembly) Brake Booster A Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)

C141C49 DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition When the voltage at terminal +BI1 is between 7.3 and 16.6 V ○ -
Malfunction Status Overcurrent is detected in the motor relay ○ -
Overcurrent is detected in the motor fail-safe relay - ○
Detection Time 0.054 seconds or more. 0.054 seconds or more.
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END