Refer to DTC C050612.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C050612
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| C050662 | Right Front Wheel Speed Sensor Signal Compare Failure | Any of the following is detected:
·
A lowest wheel speed is 10 km/h (6 mph) or more, the difference between the highest and lowest wheel speeds is 2 km/h (1 mph) or less, and the rotation direction of any one of the wheels is not detected for 15 seconds or more. ·
A vehicle speed is 30 km/h (19 mph) or more and the rotation direction of one of the wheels is different from those of other 3 wheels as well as it is not detected for 1 second or more. ·
A vehicle speed is 100 km/h, the output of reverse signal continues for 1 second or more. ·
A vehicle speed is 30 km/h or more, and the rotation direction of any one of the wheels is not detected while the other 3 wheels do not rotate in the same direction for 1 second or more. |
Front speed sensor RH (front axle hub sub-assembly RH) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| Vehicle Condition | |||||
|---|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | Pattern 4 | ||
| Diagnosis Condition | - | - | - | - | - |
| Malfunction Status | A lowest wheel speed is 10 km/h (6 mph) or more, the difference between the highest and lowest wheel speeds is 2 km/h (1 mph) or less, and the rotation direction of any one of the wheels is not detected | ○ | - | - | - |
| A vehicle speed is 30 km/h (19 mph) or more and the rotation direction of one of the wheels is different from those of other 3 wheels as well as it is not detected | - | ○ | - | - | |
| A vehicle speed is 100 km/h, the output of reverse signal continues for 1 second or more | - | - | ○ | - | |
| A vehicle speed is 30 km/h or more, and the rotation direction of any one of the wheels is not detected while the other 3 wheels do not rotate in the same direction for 1 second or more | - | - | - | ○ | |
| Detection Time | 15 seconds or more. | 1 second or more. | 1 second or more. | 1 second or more. | |
| Number of Trips | 1 trip | 1 trip | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Turn the ignition switch off.
Procedure1
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C050662 is not output | A |
| C050662 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B