Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8)  


DESCRIPTION

Code Tester Display Measurement Item Trouble Area Output ECU
X20D8 Zero Point Calibration of Steering Angle Sensor Not Acquired History of being unable to obtain the steering angle zero point
·

Sensor installation

·

Yaw rate and acceleration sensor (airbag ECU assembly)


No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle control history (RoB) may be output during situations when the steering sensor zero point calibration temporarily cannot be acquired, such as when the stop light is stuck ON.

·

After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY



PROCEDURE

1.CHECK DTC (HEALTH CHECK)
a.

Perform the Health Check using the GTS.


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the yaw rate and acceleration sensor (airbag ECU assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate and acceleration sensor (airbag ECU assembly) is tightened to the specified torque.

The yaw rate and acceleration sensor (airbag ECU assembly) is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

3.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR

NG

6.INSTALL AIRBAG ECU ASSEMBLY CORRECTLY
3.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.

HINT:

When driving at a speed of 15 km/h or more for 1 second or more, the slip indicator light turns off.



Result:
Proceed to
NEXT



NEXT

4.CLEAR VEHICLE CONTROL HISTORY (RoB)
4.CLEAR VEHICLE CONTROL HISTORY (RoB)
a.

Using the GTS, clear the Vehicle Control History (RoB).

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055

Result:
Proceed to
NEXT



NEXT

5.CHECK VEHICLE CONTROL HISTORY (RoB)
5.CHECK VEHICLE CONTROL HISTORY (RoB)
a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


b.

Using the GTS, check for Vehicle Control History (RoB).

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055

Result:
Result Proceed to
X20D8 is not output. A
X20D8 is output. B



A

END

B

6.INSTALL AIRBAG ECU ASSEMBLY CORRECTLY

NEXT

4.CLEAR VEHICLE CONTROL HISTORY (RoB)