Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448071 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
B605606N01
3.229,2.146 3.979,2.313 0.75,0.167 3.208,2.104 4.01,2.344 0.802,0.24 5.521,2.083 6.208,2.083 false 6.323,0.521 6.854,0.521 false 6.323,0.198 6.885,0.198 false 1.094,2.49 1.615,2.49 false 2.135,3.083 2.5,3.083 false 3.063,2.354 3.063,2.208 3.063,2.208 3.229,2.208 false 6.302,0.813 6.823,0.813 false 5.854,0.698 6.625,1.042 0.771,0.344 18 false 5, 7 6.125,0.385 6.406,0.74 0.281,0.354 18 false 4 6.26,1.958 6.542,2.313 0.281,0.354 18 true 3 0.917,2.344 1.198,2.698 0.281,0.354 18 true 2 1.958,2.958 2.24,3.313 0.281,0.354 18 false 1 2.156,1.594 2.469,1.792 0.313,0.198 10 false x 2 3.156,2.375 3.469,2.573 0.313,0.198 10 false x 3 3.26,2.146 4.49,2.302 1.229,0.156 8 false 17.5 (178, 13) 6.125,0.063 6.896,0.406 0.771,0.344 18 false 6

Procedure Part Name Code
Z101186

Z101188

Z101187

1 AIRBAG SENSOR ASSEMBLY 89170A (Click here) - -
2 NO. 2 CONSOLE BOX MOUNTING BRACKET 58996A - - -
3 CONSOLE BOX ASSEMBLY 58810J - - -
4 CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
5 PERFORM DIAGNOSTIC SYSTEM CHECK - - - (Click here)
6 CHECK SRS WARNING LIGHT - (Click here) - -
7 INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL - - - (Click here)

V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) - -

PROCEDURE

Hide 89170A 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B593222C02
2.229,1.792 2.49,2 0.26,0.208 10 true 3 0.802,0.708 0.958,0.906 0.156,0.198 10 true 1 1.979,0.396 2.135,0.594 0.156,0.198 10 true 2 0.479,0.042 1.375,0.396 0.896,0.354 18 false i, ii, iii 3.875,0.104 4.771,0.458 0.896,0.354 18 false iv 2.271,2.552 3.167,2.906 0.896,0.354 18 false iv
V113147

Push in - -


i.

Temporarily install the airbag sensor assembly with the 3 bolts.


ii.

Tighten the 3 bolts in the order shown in the illustration.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag sensor assembly with a new one.

·

When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.




iii.

Check that there is no looseness in the installation parts of the airbag sensor assembly.


iv.

Connect the 3 connectors and push in the lock lever to lock the connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.




Hide 58996A 2.INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET

Hide 58810J 3.INSTALL CONSOLE BOX ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 5. PERFORM DIAGNOSTIC SYSTEM CHECK

Hide 7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART