When ABS, TRC, VSC or trailer sway control is operating, the No. 2 skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred.
When a communication malfunction with the EV control ECU is detected, TRC and VSC are disabled. Also, TRC and VSC are disabled when a DTC is stored.
When in VSC off mode, or TRC and VSC are disabled, the multi-information display in the combination meter assembly displays "Traction Control Turned Off" and the VSC OFF indicator light illuminates to inform the driver.
After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
Check whether the slip indicator light was illuminated when VSC did not operate.
The slip indicator light was illuminated.
When a DTC is stored, the slip indicator light is illuminated and VSC does not operate due to the fail-safe function.
Check whether the vehicle speed was 15 km/h (9 mph) or less when VSC did not operate.
The vehicle speed was 15 km/h (9 mph) or less.
VSC does not operate when the vehicle speed is 15 km/h (9 mph) or less.
Check whether the vehicle was driven straight for a few seconds at 35 km/h (22 mph) or more.
The vehicle was not driven straight for a few seconds at 35 km/h (22 mph) or more.
When the ignition switch is turned to ON, as steering sensor zero point calibration is not performed below 35 km/h (22 mph), VSC will not operate until the vehicle is driven straight for a few seconds at 35 km/h (22 mph) or more.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the DTCs (electronically controlled brake system) that are output.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| Electronically controlled brake system DTCs are output. | B |
A
B
Check that the tire of each wheel is the correct size.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
The tire of each wheel is the correct size.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor (airbag ECU assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag ECU assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag ECU assembly) is not tilted.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION