Brake pressure sensor "F": Wheel cylinder pressure sensor 1
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| C05C816 | Brake Pressure Sensor "F" Circuit Voltage Below Threshold | Wheel cylinder pressure sensor 1 value is below -0.744 MPa (-7.6 kgf/cm2, -107 psi) for 5 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05C81F | Brake Pressure Sensor "F" Circuit Intermittent | Fluctuation of the sensor signal exceeds the threshold (15 MPa (153.0 kgf/cm2, 2175 psi) or more from the previous value) for 0.1 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05C829 | Brake Pressure Sensor "F" Signal Invalid | Data from the sensor is invalid for 0.2 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05C831 | Brake Pressure Sensor "F" No Signal | Communication with the sensor is invalid for 0.1 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05C896 | Brake Pressure Sensor "F" Component Internal Failure | A malfunction is detected by self-diagnosis function of the sensor. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C110816 | Brake Pressure Sensor "F" Supply Voltage Circuit Voltage Below Threshold | The supplied voltage to the sensor is less than a certain value for 1 second or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C110817 | Brake Pressure Sensor "F" Supply Voltage Circuit Voltage Above Threshold | The supplied voltage to the sensor is a certain value or more for 1 second or more. | No. 2 skid control ECU (brake actuator assembly) | Brake/EPB | A | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT