Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C10001C  Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range  


DESCRIPTION

The thermistor monitors and outputs the temperature of the motor relay of the brake actuator assembly to the No. 2 skid control ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C10001C Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range The difference in the temperature of the 2 thermistors is above a certain amount for 0.2 seconds or more. No. 2 skid control ECU (brake actuator assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY

NEXT

END