Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C124F62  Yaw Rate Sensor Signal Compare Failure  


DESCRIPTION

The yaw rate and acceleration sensor has a built-in airbag ECU assembly.

This DTC is stored when the No. 2 skid control ECU (brake actuator assembly) detects improper installation of the yaw rate sensor or an abnormality in the difference between the yaw rate and acceleration sensor (airbag ECU assembly) value and the control value estimated based on the yaw rate and acceleration sensor (airbag ECU assembly), steering sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C124F62 Yaw Rate Sensor Signal Compare Failure A yaw rate sensor comparison malfunction status continues.
·

Yaw rate sensor (airbag ECU assembly) installation

·

Yaw rate sensor (airbag ECU assembly)


Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate sensor, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.READ VALUE USING GTS (YAW RATE SENSOR)

Pre-procedure1

a.

Perform a road test.


Procedure1

b.

Check the yaw rate sensor output value displayed on the GTS.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Yaw Rate Sensor Value Yaw rate sensor Min.: -128°/s
Max.: 127°/s
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Chassis > Brake/EPB > Data List
Tester Display
Yaw Rate Sensor Value
50003 435 29
Result:
Result Proceed to
NG (The yaw rate sensor output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning.) A
NG (The yaw rate sensor output value is not 0°/s when the vehicle is stationary.) B
OK C



Post-procedure1

c.

None



A

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION

B

C

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION

Pre-procedure1

a.

Turn the ignition switch off.


Procedure1

b.

Check that the yaw rate sensor (airbag ECU assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate sensor (airbag ECU assembly) is tightened to the specified torque.

The yaw rate sensor (airbag ECU assembly) is not installed in a tilted position.


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

NG