If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.
As a result, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 2 speaker assembly | A |
| Rear speaker assembly | B |
If sound cannot be heard from any speaker, inspect all of them.
A
B
Disconnect the D66 radio and display receiver assembly connector.
Disconnect the E1 and E19 front No. 1 speaker assembly connectors.
Disconnect the D85 and D84 front No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D66,D85,D84,E1,E19)Location & Routingewd_type=routing;type=c,c,c,c,c;code=D66,D85,D84,E1,E19 Click Connector(D66)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D66;pinno=1,6,2,7 Click Connector(D85)Instrument Panel>Instrument Panel Wire>Front No. 3 Speaker Assembly LHewd_type=component;type=c;code=D85;pinno=4,2,3,1 Click Connector(D84)Instrument Panel>Instrument Panel Wire>Front No. 3 Speaker Assembly RHewd_type=component;type=c;code=D84;pinno=4,2,3,1 Click Connector(E1)Body>Front Door Wire LH / Front Door Wire RH>Front No. 1 Speaker Assembly RHewd_type=component;type=c;code=E1;pinno=2,1 Click Connector(E19)Body>Front Door Wire LH / Front Door Wire RH>Front No. 1 Speaker Assembly LHewd_type=component;type=c;code=E19;pinno=2,1 |
||
| D66-1 (FR+) - D85-4 (TWR+) | Always | Below 1 Ω |
| D66-6 (FR-) - D85-2 (TWR-) | Always | Below 1 Ω |
| D66-2 (FL+) - D84-4 (TWL+) | Always | Below 1 Ω |
| D66-7 (FL-) - D84-2 (TWL-) | Always | Below 1 Ω |
| E1-2 (+) - D85-3 (+) | Always | Below 1 Ω |
| E1-1 (-) - D85-1 (-) | Always | Below 1 Ω |
| E19-2 (+) - D84-3 (+) | Always | Below 1 Ω |
| E19-1 (-) - D84-1 (-) | Always | Below 1 Ω |
| D66-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| D66-6 (FR-) - Body ground | Always | 10 kΩ or higher |
| D66-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| D66-7 (FL-) - Body ground | Always | 10 kΩ or higher |
| E1-2 (+) - Body ground | Always | 10 kΩ or higher |
| E1-1 (-) - Body ground | Always | 10 kΩ or higher |
| E19-2 (+) - Body ground | Always | 10 kΩ or higher |
| E19-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Check the malfunction disappears.
Malfunction disappears.
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both the LH and RH sides.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the D66 radio and display receiver assembly connector.
Disconnect the F7 and F18 rear speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D66,F7,F18)Location & Routingewd_type=routing;type=c,c,c;code=D66,F7,F18 Click Connector(D66)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D66;pinno=4,9,3,8 Click Connector(F7)Body>No. 1 Rear Door Wire / No. 2 Rear Door Wire>Rear Speaker Assembly RHewd_type=component;type=c;code=F7;pinno=2,1 Click Connector(F18)Body>No. 1 Rear Door Wire / No. 2 Rear Door Wire>Rear Speaker Assembly LHewd_type=component;type=c;code=F18;pinno=2,1 |
||
| D66-4 (RR+) - F7-2 (+) | Always | Below 1 Ω |
| D66-9 (RR-) - F7-1 (-) | Always | Below 1 Ω |
| D66-3 (RL+) - F18-2 (+) | Always | Below 1 Ω |
| D66-8 (RL-) - F18-1 (-) | Always | Below 1 Ω |
| D66-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| D66-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| D66-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| D66-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG