Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0453477 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P0A9563  High Voltage Fuse Accumulated Load History  


DESCRIPTION

The battery ECU assembly estimates the thermal load of the high voltage fuse. If the accumulated thermal load exceeds the threshold, the battery ECU assembly will store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P0A9563 High Voltage Fuse Accumulated Load History Accumulated thermal load of the high voltage fuse estimated by the battery ECU assembly exceeds the threshold.
(1 trip detection logic)
EV battery terminal block Master Warning:
Does not come on
EV Battery A

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 10 minutes or more.

3.

Turn the ignition switch to ON and wait for 5 seconds or more.

4.

Enter the following menus: Powertrain / EV Battery / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




CAUTION / NOTICE / HINT

HINT:

If the EV battery terminal block has been replaced, make sure to perform "High Voltage Fuse Accumulated Load History Reset" and then clear the DTCs.


PROCEDURE

1.REPLACE EV BATTERY TERMINAL BLOCK

NEXT

2.PERFORM UTILITY (High Voltage Fuse Accumulated Load History Reset)
2.PERFORM UTILITY (High Voltage Fuse Accumulated Load History Reset)

NEXT

3.CLEAR DTC (EV BATTERY)
3.CLEAR DTC (EV BATTERY)

Pre-procedure1

a.

None.


Procedure1

a.

Clear the DTCs and freeze frame data.

Powertrain > EV Battery > Clear DTCs
50002 398

Result:
Proceed to
NEXT


Post-procedure1

a.

Turn the ignition switch off.



NEXT

COMPLETED