Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455727 ELECTRIC PARKING BRAKE SYSTEM L

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  PRECAUTION  


TROUBLESHOOTING PRECAUTIONS


a.

When inspecting the rear brakes, disconnect the connector of the No. 2 skid control ECU (brake actuator assembly) or disconnect the cable from the negative (-) auxiliary battery terminal in order to shut off the supply of electrical power.

CAUTION:
·
C445072

Do not perform the rear brake inspection while either the No. 2 skid control ECU (brake actuator assembly) connector or the negative (-) auxiliary battery terminal are connected.

·

The parking brake actuator assembly with bracket could operate, resulting in an accident such as your hand being caught.




b.

When disconnecting a connector or removing a fuse or relay, make sure that the ignition switch has been off, the brake pedal has not been depressed, and the driver door has been closed for 4 minutes or more*.

*: The electric parking brake may still operate up to 60 minutes depending on the state of the vehicle after the ignition switch is turned off, so be sure to perform the work procedures with the vehicle on a level surface.



c.

When any parts have been removed or installed, check for DTCs after completion of installation to confirm that the system is operating correctly.

HINT:

After performing work procedures such as installation, if the parking brake indicator light is blinking, the parking brake must be released.




HANDLING PRECAUTIONS


a.

When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force may not be sufficient. Make sure to pull the electric parking brake switch assembly to the lock side 2 times (2 lock operations).

HINT:
·

The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag ECU assembly).

·

When the parking brake indicator is illuminated after the electric parking brake switch assembly has been pulled to the lock side, the maximum amount of braking force is applied if the electric parking brake switch assembly is pulled to the lock side one more time.




b.

The parking brake indicator light blinks when the ignition switch is turned to ON after replacing the No. 2 skid control ECU (brake actuator assembly). Operate the electric parking brake switch assembly to turn off the parking brake indicator light.


c.

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


d.

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>UTILITY


e.

When replacing the No. 2 skid control ECU (brake actuator assembly), always check that ECU security key is registered.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY


f.

After replacing the parking brake actuator assembly with bracket, perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>UTILITY



PRECAUTIONS FOR TOWING VEHICLES


a.

For towing precautions: Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PARKING BRAKE FORCED RELEASE METHOD


a.

For the parking brake forced release method: Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD