Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455111 TOYOTA PARKING ASSIST-SENSOR SYSTEM C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  C1AE096  Ultrasonic Sensor (Front Left Side) Component Internal Failure  


DESCRIPTION

The front side ultrasonic sensor (FLS sensor) is installed on the front bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the front side ultrasonic sensor (FLS sensor). If an open circuit or other malfunction occurs in the front side ultrasonic sensor (FLS sensor), the front side ultrasonic sensor (FLS sensor) does not operate correctly.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1AE096 Ultrasonic Sensor (Front Left Side) Component Internal Failure Front side ultrasonic sensor (FLS sensor) failure
·

Front side ultrasonic sensor (FLS sensor)

·

Clearance warning ECU assembly


Clearance Warning B

CAUTION / NOTICE / HINT

NOTICE:
·

Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION

·

If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Clearance Warning > Trouble Codes
50001 438

Result:
Result Proceed to
C1AE096 is not output A
C1AE096 is output B
C1AE087 and C1AE096 are output C



A

B

2.REPLACE FRONT SIDE ULTRASONIC SENSOR (FLS SENSOR)

C

2.REPLACE FRONT SIDE ULTRASONIC SENSOR (FLS SENSOR)
a.

Replace the front side ultrasonic sensor (FLS sensor) with a known good one.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL


HINT:

All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.



Result:
Proceed to
NEXT



NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Clearance Warning > Clear DTCs
50002 438

Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Clearance Warning > Trouble Codes
50001 438

Result:
Result Proceed to
C1AE096 is not output A
C1AE096 is output B



A

END (FRONT SIDE ULTRASONIC SENSOR [FLS SENSOR] WAS DEFECTIVE)

B