Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0463852 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0AED11  Drive Motor Inverter Temperature Sensor "A" Circuit Short to Ground  P0AED15  Drive Motor Inverter Temperature Sensor "A" Circuit Short to Battery or Open  


DESCRIPTION

The MG ECU, which is built into in the inverter with converter assembly, detects the temperature of the drive motor inverter using a temperature sensor built into the inverter with converter assembly. The inverter cooling system operates independently of the FC cooling system. The MG ECU uses signals from the drive motor inverter temperature sensor to check the effectiveness of the inverter cooling system. If necessary, the MG ECU will limit inverter output to help prevent inverter overheating. The MG ECU also detects malfunctions in the drive motor inverter temperature sensor and its wiring.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P0AED11 Drive Motor Inverter Temperature Sensor "A" Circuit Short to Ground Short to ground in the drive motor inverter temperature sensor circuit
(1 trip detection logic)
Inverter with converter assembly Master Warning:
Comes on
EV A
P0AED15 Drive Motor Inverter Temperature Sensor "A" Circuit Short to Battery or Open Open or short to +B in drive motor inverter temperature sensor circuit
(1 trip detection logic)
Inverter with converter assembly Master Warning:
Comes on
EV A

Related Data List
DTC No. Data List
P0AED11 Motor Inverter Temperature
P0AED15

CONFIRMATION DRIVING PATTERN

HINT:

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY


1.

Turn the ignition switch to ON and wait for 5 seconds or more.

2.

Enter the following menus: Powertrain / EV / Utility / All Readiness.

3.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY

NEXT

COMPLETED