Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0455058 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B009884  Right Side Restraints Sensor 3 Signal Below Allowable Range  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority Test Mode / Check Mode
B009884 Right Side Restraints Sensor 3 Signal Below Allowable Range Either condition is met:
·

A rear airbag sensor RH malfunction.

·

An airbag ECU assembly malfunction.


·

Rear airbag sensor RH

·

Airbag ECU assembly


Comes on SRS Airbag A Not applicable

WIRING DIAGRAM

C450171E02
1.594,0.677 1.75,0.875 0.156,0.198 10 false 2 1.583,1.479 1.74,1.677 0.156,0.198 10 false 1 2.854,0.656 3.01,0.854 0.156,0.198 10 false 1 2.844,1.479 3,1.677 0.156,0.198 10 false 2 4.146,0.667 4.302,0.865 0.156,0.198 10 false 4 5.333,0.656 5.646,0.854 0.313,0.198 10 false 32 5.365,1.49 5.677,1.688 0.313,0.198 10 false 31 4.177,1.49 4.333,1.688 0.156,0.198 10 false 3 5.635,0.813 6.25,1.01 0.615,0.198 10 false BBL+ 5.635,1.573 6.25,1.771 0.615,0.198 10 false BBL- 0.094,2.219 0.406,2.417 0.313,0.198 10 false E23 0.094,2.365 2.229,2.583 2.135,0.219 10 false Side Airbag Pressure Sensor LH 2.896,2.208 3.208,2.406 0.313,0.198 10 false G63 2.906,2.365 4.354,2.563 1.448,0.198 10 false Rear Airbag Sensor LH 5.51,2.24 6.125,2.438 0.615,0.198 10 false G43 5.521,2.406 6.948,2.635 1.427,0.229 10 false Airbag ECU Assembly 3.073,0.781 3.688,0.979 0.615,0.198 10 false BDL+ 3.083,1.573 3.698,1.771 0.615,0.198 10 false BDL- 3.708,0.781 4.323,0.979 0.615,0.198 10 false BCL+ 3.708,1.583 4.323,1.781 0.615,0.198 10 false BCL- 1.094,0.781 1.708,0.979 0.615,0.198 10 false BDL+ 1.083,1.604 1.698,1.802 0.615,0.198 10 false BDL-

CAUTION / NOTICE / HINT

NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the auxiliary battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


·

After replacing the airbag ECU assembly, refer to initialization.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE



PROCEDURE

1.CHECK REAR AIRBAG SENSOR RH
a.
C374693C37
0.979,1.552 1.292,1.708 0.313,0.156 10 false *1 2.458,1.417 2.771,1.573 0.313,0.156 10 false *2 1.677,1.292 1.99,1.448 0.313,0.156 10 false *3
*1 Rear Airbag Sensor LH
*2 Airbag ECU Assembly
*3 Wire Harness


Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.


c.

Interchange the rear airbag sensor RH with LH and connect the connectors.


d.

Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

Result:
Proceed to
NEXT



NEXT

2.CHECK REAR AIRBAG SENSOR RH
2.CHECK REAR AIRBAG SENSOR RH

Pre-procedure1

a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

a.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444

Result:
Result Proceed to
B009884 is output A
B009384 is output B
B009384 and B009884 are not output C


Post-procedure1

HINT:

Codes other than DTCs B009384 and B009884 may be output at this time, but they are not related to this check.


a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.


c.

Return the rear airbag sensor LH and RH to their original positions and connect the connectors.



A

B

C