Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448371 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B605611N01
2.573,3.427 3.333,3.427 true 5.469,1.24 6.042,1.24 true 6.323,3.781 6.667,3.781 true 4.448,2.667 5.021,2.667 true 2.51,1.781 2.979,1.781 true 6.365,0.167 6.875,0.167 false 6.438,0.573 6.813,0.573 false 3.781,4.302 3.375,4.302 true 4.479,0.313 4.792,0.51 0.313,0.198 10 false x 4 6.198,0.438 6.479,0.792 0.281,0.354 18 false 2 6.177,0.052 6.458,0.406 0.281,0.354 18 false 1 3.063,1.656 3.344,2.01 0.281,0.354 18 false 3 3.854,4.156 4.135,4.51 0.281,0.354 18 false 4 5.073,2.542 5.354,2.896 0.281,0.354 18 false 6 6.854,3.677 7.135,4.031 0.281,0.354 18 false 5 2.354,3.281 2.635,3.635 0.281,0.354 18 false 8 6.125,1.135 6.406,1.49 0.281,0.354 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 BENCH TYPE REAR SEATBACK ASSEMBLY - - - -
4 REAR DOOR SCUFF PLATE INSIDE LH 67918F - - -
5 REAR DOOR OPENING TRIM WEATHERSTRIP LH 62332A (Click here) - -
6 REAR SEAT SIDE GARNISH LH 62552F - - -
7 NO. 4 EV BATTERY INTAKE DUCT G92D4A - - -
8 REAR AIRBAG SENSOR LH 89834 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the rear airbag sensor LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 3.REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

Hide 67918F 4.REMOVE REAR DOOR SCUFF PLATE INSIDE LH

Hide 62332A 5.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Z101186

HINT:

Remove the rear side of the rear door opening trim weatherstrip LH so that the rear seat side garnish LH can be removed.

Click here(Click here)



Hide 62552F 6.REMOVE REAR SEAT SIDE GARNISH LH

Hide G92D4A 7.REMOVE NO. 4 EV BATTERY INTAKE DUCT

Hide 89834 8.REMOVE REAR AIRBAG SENSOR LH

a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B605612N01
4.469,0.135 4.635,0.406 0.167,0.271 18 true ii 5.854,0.813 6.073,1.094 0.219,0.281 18 true iii 2.76,0.792 2.927,1.052 0.167,0.26 18 true i

i.

Remove the bolt.


ii.

Detach the claw and pull out the rear airbag sensor LH.

NOTICE:

If the rear airbag sensor LH has been dropped, replace it with a new one.



iii.

Disconnect the airbag connector to remove the rear airbag sensor LH.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR