Home › Engine / Hybrid System › FC CONTROL › WATER TEMPERATURE SENSOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466408 WATER TEMPERATURE SENSOR A

FC CONTROL  WATER TEMPERATURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A482354N04
1.74,0.781 2.448,0.958 0.708,0.177 2.052,3.458 3.042,3.667 0.99,0.208 0.865,4.844 0.865,4.479 false 1.083,2.198 1.542,2.198 false 4.594,0.75 5.031,0.75 false 6.479,0.292 6.781,0.292 false 6.479,0.719 6.781,0.719 false 6.271,2.802 6.438,3.135 6.438,3.135 6.635,3.135 false 6.385,3.771 6.604,3.552 6.604,3.552 6.771,3.552 false 6.083,3.969 6.281,4.24 6.281,4.24 6.417,4.24 false 3.927,3.958 4.281,3.708 4.281,3.708 4.469,3.708 false 3.344,3.865 3.729,3.865 false 3.271,2.948 3.271,2.615 false 1.031,1.823 1.031,0.865 1.031,0.865 1.74,0.865 false 1.49,1.177 1.49,0.865 false 1.823,4.031 1.823,3.563 1.823,3.563 2.042,3.563 true 3.188,3.771 3.344,3.969 0.156,0.198 10 false ● 6.813,3.458 6.969,3.656 0.156,0.198 10 false ● 6.792,4.115 7.021,4.448 0.229,0.333 18 false 1 4.844,3.563 5.104,3.906 0.26,0.344 18 false 2 6.271,0.583 6.49,0.906 0.219,0.323 18 false 3 6.281,0.135 6.49,0.427 0.208,0.292 18 false 4 0.792,4.865 1.052,5.208 0.26,0.344 18 false 5 1.583,2.052 1.833,2.385 0.25,0.333 18 false 6 3.208,2.99 3.448,3.323 0.24,0.333 18 false 7 5.083,0.615 5.354,0.938 0.271,0.323 18 false 8 6.688,2.99 6.865,3.281 0.177,0.292 18 false 9 3.854,0.385 4.125,0.594 0.271,0.208 10 false x 6 1.781,0.792 2.469,0.979 0.688,0.188 8 false 49 (500, 36) 4,1.688 4.271,1.896 0.271,0.208 10 false x 6 6.292,1.969 6.563,2.177 0.271,0.208 10 false x 6 2.094,3.479 3.125,3.667 1.031,0.188 8 false 4.0 (41, 35 in.*lbf)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 WATER TEMPERATURE SENSOR (for FC Stack Side) 89422Q (Click here) - -
2 WATER TEMPERATURE SENSOR (for Radiator Side) 89422A (Click here) - -
3 ADD COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed)) - - (Click here) -
4 INSPECT FOR COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed)) LEAK - (Click here) - -
5 AIR CLEANER WITH ELEMENT ASSEMBLY WITH AIR CLEANER INLET - - - -
6 RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH 53209F - - -
7 LOWER RADIATOR AIR DEFLECTOR 53295 - - -
8 RADIATOR COVER PLATE 53291B - - -
9 UPPER RADIATOR SUPPORT SEAL 53292A - - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part

PROCEDURE

Hide 89422Q 1.INSTALL WATER TEMPERATURE SENSOR (for FC Stack Side)

a.

To prevent contamination by foreign matter, remove the protective tape from the water temperature sensor connecting portions of the FC stack water outlet immediately before performing the procedure.


b.
A480279N02
2.604,0.104 2.885,0.458 0.281,0.354 18 false i 0.844,1.688 1.125,2.052 0.281,0.365 18 false ii 4.125,1.688 4.677,2.042 0.552,0.354 18 false iii, iv

i.

Apply a light coat of engine coolant to the O-ring of the water temperature sensor


ii.

Install the water temperature sensor to the FC stack water outlet with a new clip.

NOTICE:
·

If the water temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

·

If reusing the water temperature sensor, be sure to inspect the O-ring.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




iii.

Attach the clamp and connect the wire harness.


iv.

Connect the water temperature sensor connector.



Hide 89422A 2.INSTALL WATER TEMPERATURE SENSOR (for Radiator Side)

a.

To prevent contamination by foreign matter, remove the protective tape from the water temperature sensor connecting portions of the No. 1 FC radiator pipe immediately before performing the procedure.


b.
A480278N02
4.083,1.677 4.917,2.031 0.833,0.354 18 false iii, iv 2.594,0.104 3.427,0.458 0.833,0.354 18 false i 0.844,1.688 1.677,2.042 0.833,0.354 18 false ii

i.

Apply a light coat of engine coolant to the O-ring of the water temperature sensor.


ii.

Install the water temperature sensor to the No. 1 FC radiator pipe with a new clip.

NOTICE:
·

If the water temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

·

If reusing the water temperature sensor, be sure to inspect the O-ring.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




iii.

Attach the clamp and connect the wire harness.


iv.

Connect the water temperature sensor connector.



Hide 3.ADD COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))

Hide 4.INSPECT FOR COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed)) LEAK

Hide 5.INSTALL AIR CLEANER WITH ELEMENT ASSEMBLY WITH AIR CLEANER INLET

Hide 53209F 6.INSTALL RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

Hide 53295 7.INSTALL LOWER RADIATOR AIR DEFLECTOR

Hide 53291B 8.INSTALL RADIATOR COVER PLATE

Hide 53292A 9.INSTALL UPPER RADIATOR SUPPORT SEAL