| *1 | ROCKER PANEL MOULDING LH | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75858A
1.REMOVE ROCKER PANEL MOULDING COVER LH
Heat the adhesive of the rocker panel moulding cover LH using a heat light.
| Part | Temperature |
|---|---|
| Rocker Panel Moulding Cover LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rocker panel moulding cover LH excessively.
Remove the rocker panel moulding cover LH.
75864B
2.REMOVE NO. 4 ROCKER PANEL MOULDING PROTECTOR
Heat the adhesive of the No. 4 rocker panel moulding protector using a heat light.
| Part | Temperature |
|---|---|
| No. 4 Rocker Panel Moulding Protector | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the No. 4 rocker panel moulding protector excessively.
Remove the No. 4 rocker panel moulding protector.
76926F
3.REMOVE SIDE MUDGUARD PROTECTOR LH
Heat the adhesive of the side moulding protector LH using a heat light.
| Part | Temperature |
|---|---|
| Side Moulding Protector LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the side moulding protector LH excessively.
Remove the side moulding protector LH.
75897B
4.REMOVE NO. 3 MOULDING TAPE
Heat the adhesive of the No. 3 moulding tape using a heat light.
| Part | Temperature |
|---|---|
| No. 3 Moulding Tape | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the No. 3 moulding tape excessively.
Remove the 3 No. 3 moulding tapes.
75861C
5.REMOVE ROCKER PANEL MOULDING PAD
Heat the adhesive of the rocker panel moulding pad using a heat light.
| Part | Temperature |
|---|---|
| Rocker Panel Moulding Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rocker panel moulding pad excessively.
Remove the 2 rocker panel moulding pads.