Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P1D8F00  FC Air Compressor Motor Control Module Performance  


DESCRIPTION

The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly.

HINT:

P1D8F00 may be output immediately after the ignition switch is turned to ON due to decrease in the auxiliary battery voltage. In this case, check the auxiliary battery voltage, and if the result is equal to or less than the standard value, charge the auxiliary battery.


DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P1D8F00 FC Air Compressor Motor Control Module Performance MG ECU internal malfunction:
Run pulse signal cycle deviation or stop
(1 trip detection logic)
·

Auxiliary battery

·

Inverter with converter assembly


Master Warning: Comes on EV A

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the ignition switch to ON and wait for 5 seconds or more.



PROCEDURE

1.CHECK FREEZE FRAME DATA (AUXILIARY BATTERY VOLTAGE)

Pre-procedure1

a.

None


Procedure1

b.

Read the freeze frame data of DTC P1D8F00.

Powertrain > EV > DTC(P1D8F00) > Freeze Frame Data
Tester Display
Auxiliary Battery Voltage
50040 397 225 P1D8F00
Result:
Result Proceed to
The value of Auxiliary Battery Voltage is less than 11 V A
The value of Auxiliary Battery Voltage is 11 V or more B



Post-procedure1

c.

Turn the ignition switch off.



A

2.CHECK AUXILIARY BATTERY

B

REPLACE INVERTER WITH CONVERTER ASSEMBLY

2.CHECK AUXILIARY BATTERY

NEXT

END