| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | TELEMATICS TRANSCEIVER | 86741A | - | - | - |
| 3 | TRANSCEIVER COVER | 86742A | - | - | - |
| 4 | MOBILEPHONE BATTERY | 86725 | - | - | - |
| *A | for eCall | *B | for TOYOTA Connect |
| *C | for Type A | *D | for Type B |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the mobilephone battery removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standardposition is recognized. | - |
1. PRECAUTION
86741A
2.REMOVE TELEMATICS TRANSCEIVER
86742A
3.REMOVE TRANSCEIVER COVER
for eCall:
| *A | for Type A | *B | for Type B |
for TOYOTA Connect:
|
Remove in this Direction | - | - |
86725
4.REMOVE MOBILEPHONE BATTERY
for eCall:
| *A | for Type A | *B | for Type B |
for TOYOTA Connect: