Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0483296 OCCUPANT CLASSIFICATION ECU A

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B615281N01
5.25,1.406 5.781,1.406 false 1.74,2.969 2.344,2.969 false 6.51,0.25 6.813,0.25 false 5.833,1.302 6.115,1.656 0.281,0.354 18 false 2 2.427,2.833 2.708,3.188 0.281,0.354 18 false 3 6.344,0.115 6.625,0.469 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT SEAT ASSEMBLY RH - - - -
3 OCCUPANT DETECTION ECU 89952 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Memorize steering angle neutral point Panoramic View Monitor System (Click here)
·

Occupant detection ECU (Including removal and installation)

·

Front seat assembly RH (Only for removal and installation)


Zero point calibration (Occupant classification system)
·

Occupant classification system

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.REMOVE FRONT SEAT ASSEMBLY RH

Z101186

HINT:

Use the same procedure as for the LH side.

Click here(Click here)



Hide 89952 3.REMOVE OCCUPANT DETECTION ECU

a.

for 8 Way Seat Type:

B593287C01
0,0 0,0 false
V113147

Remove in this Direction - -



b.

for 4 Way Seat Type:

B602667C01
0,0 0,0 false
V113147

Remove in this Direction - -