Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for TOYOTA Connect) › from 2021.08
RM37H0E _56 Audio / Visual / Telematics _095262 TELEMATICS _0484973 TELEMATICS SYSTEM(for TOYOTA Connect) D

TELEMATICS  TELEMATICS SYSTEM(for TOYOTA Connect)  VEHICLE CONTROL HISTORY (RoB)  


NOTICE:

Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.


CHECK VEHICLE CONTROL HISTORY


a.

Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55
Vehicle Control History Item
Code Tester Display Description Diagnostic Note
X2210 Life Cycle of DCM Backup Battery When the system detects that the mobilephone battery has reached the end of its lifespan.
·

The emergency call switch red indicator blinks

·

Replace mobilephone battery

(Click here)


NOTICE:
·

After replacing the mobilephone battery, perform initialization.

(Click here)

·

After performing work, perform "CLEAR VEHICLE CONTROL HISTORY" to turn off the emergency call switch red indicator.



X2211 Low DCM Backup Battery Charge When the mobilephone battery charge is low. -
X2601 Software Inconsistency with ENG/HV Control Module The VIN number received via CAN communication does not match that stored in the DCM.
·

The emergency call switch red indicator blinks

·

Perform VIN Synchronization

(Click here)


X2214 Communication Blackout from Power Distribution Controller ECU Lost Communication with ECM. Check CAN Communication System
(Click here)
X2213 Emergency Call Switch Stuck On The emergency call switch is on for 5 minutes or more Replace map light assembly
(Click here)
X2212 Diagnostics Communication Flow Failure Diagnostics communication flow failure (ID, Mode/SID difference). -
X2215 Non Approval of the Reprograming User did not approve software update. -
X2216 Failure of the Reprogramming Software writing failed. -
X2217 Inconsistent Startup Software Software writing succeeded, but started software does not match package. -
X2218 Communication Blackout from Body Controller ECU Lost communication with main body ECU (multiplex network body ECU) Check CAN Communication System
(Click here)



CLEAR VEHICLE CONTROL HISTORY


NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.


a.

Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55

b.

According to the display on the GTS, clear the Vehicle Control History (RoB).