Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › from 2021.08
RM37H0E _58 Vehicle Interior _095297 SEAT BELT _0455415 SEAT BELT WARNING SYSTEM Y

SEAT BELT  SEAT BELT WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the seat belt warning system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS

Result:
Proceed to
NEXT



NEXT

3.PRE-CHECK
3.PRE-CHECK
a.

Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


b.

Check the fuses and relays.


c.

Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.


Result:
Proceed to
NEXT



NEXT

4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Using the GTS, check for CAN communication system DTCs.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN DTCs are not output (w/o Occupant Classification System) A
CAN DTCs are not output (w/ Occupant Classification System) B
CAN DTCs are output C



A

5.CHECK COMBINATION METER ASSEMBLY

B

10.CHECK DTC OUTPUT (AIRBAG SYSTEM)*

C

5.CHECK COMBINATION METER ASSEMBLY
a.

Check the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.

OK:

The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.



Result:
Proceed to
OK
NG



OK

6.PROBLEM SYMPTOMS TABLE

NG

6.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

8.REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

10.CHECK DTC OUTPUT (AIRBAG SYSTEM)*
a.

Clear the DTCs.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

b.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

11.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)*

B

11.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)*
a.

Clear the DTCs.

Body Electrical > Occupant Detection > Clear DTCs
50002 394

b.

Check for DTCs.

Body Electrical > Occupant Detection > Trouble Codes
50001 59

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

5.CHECK COMBINATION METER ASSEMBLY

B