| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | FRONT SEAT ASSEMBLY LH | - | - | - | - |
| 3 | SEAT HEATER CONTROL SUB-ASSEMBLY LH | 87501B | - | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the seat heater control removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
87501B
3.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH
| *A | for Driver Side | *B | for Front Passenger Side |
|
Remove in this Direction | - | - |