Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


  1. Install the curtain shield airbag with the 9 bolts and 3 clips in the order shown in the illustration.

    NOTICE:
    Do not twist the curtain shield airbag assembly when installing it.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



    H043773E04



    H042953E01
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL ROOF HEADLINING ASSEMBLY
  1. Install the roof headlining (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



5. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).