Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connector to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



2. INSTALL STEERING COLUMN COVER
  1. Engage the 4 claws to install the steering column upper cover and steering column lower cover.

    HINT:
    Fully tilt down the steering column when installing the steering column upper cover and fully tilt it up when installing the steering column cover.



3. POSITION SPIRAL CABLE


H043750E02
  1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.



    H043751E02
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to the left and right from the center.



4. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and steering main shaft.

  1. Install the steering wheel with the set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



5. INSTALL STEERING PAD ASSEMBLY


H043738E03
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Using a T30 "TORX" socket, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



6. INSTALL NO. 2 STEERING WHEEL COVER LOWER


7. INSTALL NO. 3 STEERING WHEEL COVER LOWER


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. INSPECT STEERING PAD ASSEMBLY


H043732E02
  1. Perform a diagnostic system check (Click here).

  1. With the steering pad (with airbag) installed on the vehicle, perform a visual check:

    1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
    1. If any of the defects mentioned above are present, replace the steering pad assembly with a new one.

      CAUTION:
      For removal and installation of the steering pad assembly, be sure to follow the correct procedures.



10. PERFORM INITIALIZATION

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  1. Perform initialization (Click here).



11. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).



12. INSPECT STEERING WHEEL POSITION