SEAT POSITION SENSOR > INSTALLATION |
| 1. INSTALL SEAT POSITION SENSOR |
![]() |
Check that the power switch is off.
Check that the negative battery (-) terminal is disconnected.
Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.
Using a "torx" socket wrench (T30), tighten the "torx" screw to install the seat position sensor.
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector.
Install the seat slide position sensor protector to the seat position sensor.
| 2. INSTALL FRONT SEAT ASSEMBLY |
Install the front seat assembly (Click here).
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 5. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).