Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

HYBRID BATTERY SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT TECHSTREAM TO DLC3*

        HINT:
        If the display indicates a communication fault in the tester, inspect the DLC3.


      NEXT


      4.CHECK AND RECORD DTC AND FREEZE FRAME DATA*
      1. Refer to the the DTC CHECK / CLEAR (Click here).

        HINT:
        If a DTC related to the CAN communication system malfunction is output, first troubleshoot and repair the CAN communication system (Click here).


      NEXT


      5.CLEAR DTC*
      1. Refer to the the DTC CHECK / CLEAR (Click here).


      NEXT


      6.PROBLEM SYMPTOM CONFIRMATION
      1. When a malfunction does not occur, go to A.

      2. When a malfunction occurs, go to B.



      B.
      Go to step 8
      A


      7.SYMPTOM SIMULATION

        NEXT


        8.CHECK DTC*
        1. Refer to the the DTC CHECK / CLEAR (Click here).


        NEXT


        9.DTC CHART
        1. Refer to the the DIAGNOSTIC TROUBLE CODE CHART (Click here).


        NEXT


        10.CIRCUIT INSPECTION

          NEXT


          11.IDENTIFICATION OF PROBLEM

            NEXT


            12.ADJUSTMENT AND/OR REPAIR

              NEXT


              13.CONFIRMATION TEST

                NEXT

                END