ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.START HYBRID CONTROL SYSTEM |
| Result | Proceed to |
| Power switch cannot be turned ON (ACC) or when hybrid control system can be started | A |
| Power switch can be turned ON (ACC) and hybrid control system cannot be started | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Delete the DTC.
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
| Result | Proceed to |
| DTC reoccurs | A |
| DTC does not reoccur | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
DATA LIST/ACTIVE TEST (Click here)
Terminals of ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|