Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

DTC    P0A95    High Voltage Fuse

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
P0A95
Voltage between VBB9 and VBB10 terminals is below standard in spite of interlock switch being engaged (1 trip detection logic)
  1. High voltage fuse
  2. Service plug grip
  3. Battery plug
  4. Battery ECU

WIRING DIAGRAM


C118375E01


INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are servicing the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals.

HINT:
At least 5 minutes are required to discharge the high-voltage condenser inside the inverter.

1.READ DTC OUTPUT (DTC P0A1F IS OUTPUT)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG) and the tester ON.

  1. Enter the following menus: Powertrain / HV Battery / DTC.

  1. Read DTCs.

    Result:
    DTC P0A1F is output



YES
REPLACE BATTERY ECU
NO


2.INSPECT SERVICE PLUG GRIP

CAUTION:
Wear insulated gloves before performing the following operation.

  1. Turn the power switch OFF.



    A081749E01
  1. Remove the service plug grip (Click here).

NOTICE:
Turning the power switch ON (READY) with the service plug grip removed could cause a malfunction. Therefore, never turn the power switch ON (READY) in this state.

  1. Measure the resistance of the service plug grip.

    Standard resistance:
    Below 1 Ω



NG
Go to step 4
OK


3.INSPECT BATTERY PLUG

CAUTION:
Wear insulated gloves and goggles before performing the following operation.

  1. Remove the HV battery assembly (Click here).

  1. Remove the battery plug (Click here).



    A093184E01
  1. Measure the resistance of the battery plug.

    Standard resistance:
    Tester Connection
    Specified Condition
    A - C
    Below 1 Ω
    B - D
    Below 1 Ω

  1. Reinstall the battery plug (Click here).

  1. Reinstall the HV battery assembly (Click here).



NG
REPLACE BATTERY PLUG
OK

REPLACE BATTERY ECU 

4.INSPECT HIGH VOLTAGE FUSE

CAUTION:
Wear insulated gloves before performing the following operation.



    A057824E01
  1. Remove the high voltage fuse (Click here).

    HINT:
    The high voltage fuse is enclosed in the service plug grip.

  1. Measure the resistance of the high voltage fuse.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the high voltage fuse.



NG
REPLACE HIGH VOLTAGE FUSE
OK

REPLACE SERVICE PLUG GRIP