Home › ENGINE › 1NZ-FXE LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between the low and full marks on the oil level gauge.
    If the engine oil is low, check for oil leaks and add engine oil up to the full mark.

    NOTICE:
    Do not add engine oil above the full mark.



2. CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water intrusion, discoloring or thinning.
    If the oil quality is visibly poor, replace the oil.



3. CHECK OIL PRESSURE


A092503E02
  1. Remove the engine oil pressure switch assembly.

    1. Disconnect the oil pressure switch connector.

    2. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    A092504E01
  1. Install an oil pressure gauge.

    1. Install the adaptor, then install an oil pressure gauge.

  1. Set the vehicle to inspection mode (Click here).

  1. Warm up the engine.

  1. Check the oil pressure. If the oil pressure is not specified, check the oil pump (Click here).

    Standard oil pressure:
    Condition
    Specified Condition
    Idle
    59 kPa (0.6 kgf/cm2, 4.2 psi) or more
    2,500 rpm
    150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi)

  1. Remove the oil pressure gauge.



    A050082E12
  1. Install the engine oil pressure switch.

    1. Apply adhesive to the threads.

      Adhesive:
      Toyota Genuine Adhesive 1324, Three Bond 1324 or Equivalent

    2. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m{ 153 kgf*cm , 11 ft.*lbf }

      NOTICE:
      Do not start the engine within 1 hour of installation.

    3. Connect the oil pressure switch connector.



4. INSPECT FOR OIL LEAK