Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > INSTALLATION

for Preparation Click here



1. INSTALL BLOWER ASSEMBLY


    I038841E02
  1. Install the blower with the 3 screws.

    HINT:
    Use a repair screw (part No. 90159-70003) if the screw (A) removed before cannot be tightened.



    I038839E03
  1. Attach the 4 clamps to connect the wire harness.

  1. Connect the connectors.

  1. Install the 10 connectors of the transponder key ECU.



2. INSTALL AIR DUCT SUB-ASSEMBLY
  1. Install the air duct with the 2 screws.



3. INSTALL NO. 1 HEATER TO REGISTER DUCT


4. INSTALL NETWORK GATEWAY ECU


5. INSTALL ECU


6. INSTALL TRANSMISSION CONTROL ECU ASSEMBLY


7. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY LOWER

HINT:
Refer to the installation procedures for the instrument panel sub-assembly lower (Click here).



8. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY

HINT:
Refer to the installation procedures for the instrument panel with the passenger airbag assembly (Click here).