Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > REMOVAL

for Preparation Click here




1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY

HINT:
Refer to the removal procedures for the instrument panel with the passenger airbag (Click here).



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY LOWER

HINT:
Refer to the removal procedures for the instrument panel lower (Click here).



3. REMOVE TRANSMISSION CONTROL ECU ASSEMBLY


4. REMOVE ECM


5. REMOVE NETWORK GATEWAY ECU


6. REMOVE NO. 1 HEATER TO REGISTER DUCT


7. REMOVE AIR DUCT SUB-ASSEMBLY


    I040426E01
  1. Remove the 2 screws and air duct.



8. REMOVE BLOWER ASSEMBLY


    I038839E03
  1. Disconnect the 10 connectors.

  1. Detach the 4 clamps and disconnect the wire harness.



    I038841E01
  1. Remove the 3 screws, nut and blower.