Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1249/49    Open in Stop Light Switch Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU inputs the stop light switch signal and detects braking condition.
The skid control ECU has a circuit for open detection inside. The skid control ECU outputs the DTC if it detects an open in the stop light signal input line when the stop light switch is off, or an open in the stop light circuit (GND side).

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1249/49
520
Stop light switch circuit is open for at least 10 sec. when IG1 terminal voltage is between 9.5 V and 17.02 V
  1. Stop light switch
  2. Stop light switch circuit
  3. Stop light bulb

WIRING DIAGRAM


C126254E01


C153496E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK STOP LIGHT SWITCH OPERATION
  1. Check that the stop light comes on when the brake pedal is depressed and turns off when the brake pedal is released.
    OK 
    Pedal Condition
    Stop Light Condition
    Brake pedal depressed
    Turns on
    Brake pedal released
    Turns off

    HINT:
    Check the stop light bulb as it may have burnt out.



NG
Go to step 4
OK


2.CHECK SKID CONTROL ECU (STP VOLTAGE)


    F047485E60
  1. Measure the voltage of the connector.

    HINT:
    Measure the voltage from behind the connector with the connector connected to the skid control ECU.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S8-14 (STP) - Body ground
    Brake pedal depressed
    8 to 14 V
    S8-14 (STP) - Body ground
    Brake pedal released
    Below 1 V



NG
Go to step 5
OK


3.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch ON (READY).

  1. Check the same DTCs are recorded (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE SKID CONTROL ECU
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

4.INSPECT STOP LIGHT SWITCH ASSEMBLY


    C108891E04
  1. Disconnect the stop light switch connector.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    1 - 2
    Switch pin pushed
    10 kΩ or higher



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK


5.CHECK WIRE HARNESS (SKID CONTROL ECU - STOP LIGHT SWITCH)


    C126276E01
  1. Disconnect the S8 ECU connector.

  1. Disconnect the S16 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S8-14 (STP) - S16-1
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU