Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs by flashing the ABS warning light.

WIRING DIAGRAM


C126269E02


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK DLC3 (TC VOLTAGE)


    C108847E02
  1. Turn the power switch ON (READY).

  1. Measure the voltage of the DLC3 connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    D1-13 (TC) - Body ground
    10 to 14 V

  1. Measure the resistance of the DLC3 connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-4 (CG) - Body ground
    Below 1 Ω



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE
A

REPLACE SKID CONTROL ECU 

3.CHECK WIRE HARNESS AND CONNECTORS (DLC3 - HV CONTROL ECU)


    C133168E02
  1. Disconnect the HV control ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-13 (TC) - H14-6 (TC)
    Below 1 Ω
    D1-13 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (DLC3 - BODY GROUND)


    H100769E69
  1. Measure the resistance of the DLC3 connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE
A

REPLACE SKID CONTROL ECU