DTC C1202/68 Master Reservoir Level Malfunction |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1202/68 | 511 | When either condition below is met:
|
|
| C1202/68 | 512 | Open in switch signal circuit continues for 2 seconds or more. |
|

| 1.CHECK BRAKE FLUID LEVEL IN RESERVOIR |
Check that the brake fluid level is sufficient.
|
| ||||
| OK | |
| 2.INSPECT BRAKE FLUID LEVEL WARNING SWITCH |
![]() |
Remove the reservoir tank cap and strainer.
Disconnect the brake fluid level warning switch connector.
Measure the resistance of the switch.
| Tester Connection | Fluid Level | Specified Condition |
| B1-1 - B1-2 | Proper | 1.8 to 2.16 kΩ |
| B1-1 - B1-2 | Below minimum level | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SKID CONTROL ECU - BRAKE FLUID LEVEL WARNING SWITCH) |
![]() |
Disconnect the S10 ECU connector.
Disconnect the B1 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| S10-6 (LBL) - B1-2 | Below 1 Ω |
| S10-6 (LBL) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the power switch ON (READY).
Check that the same DTCs are recorded (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||