Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1515    Torque Sensor Zero Point Adjustment Undone

for Preparation Click here


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been performed.

DTC No.
DTC Detection Condition
Trouble Area
C1515
This DTC is detected when torque sensor zero point calibration has not been performed.
  1. Torque sensor zero point calibration
    (There is no malfunction if this DTC is not output again after performing zero point calibration.)
  2. Steering column

INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


Go to step 3

2.PERFORM ZERO POINT CALIBRATION OF TORQUE SENSOR
  1. Perform the torque sensor zero point calibration (Click here).


NEXT


3.RECONFIRM DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs are still output even after performing torque sensor zero point calibration 3 times.
    A
    DTCs are still output even after performing torque sensor zero point calibration once or twice.
    B
    Normal system code is output.
    C

    HINT:
    Replace the steering column assembly if DTCs are still output even after performing the torque sensor zero point calibration 3 times.



B
Go to step 2

C
END
A

REPLACE STEERING COLUMN ASSEMBLY