ELECTRONIC POWER STEERING SYSTEM > CALIBRATION |
| INITIALIZATION OF TORQUE SENSOR ZERO POINT CALIBRATION SIGNAL |
Center the steering wheel and align the front wheels straight ahead.
Connect the Techstream (with CAN VIM) to the DLC3.
Turn the power switch ON (IG) and then initialize the torque sensor zero point calibration signal by following the directions on the Techstream screen.
Perform steering zero point calibration after turning the power switch OFF.
| TORQUE SENSOR ZERO POINT CALIBRATION |
Center the steering wheel and align the front wheels straight ahead.
Connect the Techstream (with CAN VIM) to the DLC3.
Turn the power switch ON (IG) and then perform the zero point calibration by following the directions on the Techstream screen.
Confirm that no DTCs are output after completing the operation.
When DTC C1515 is output, refer to the following procedures (Click here).
When DTC C1516 is output, refer to the following procedures (Click here).
When DTC C1534 is output, refer to the following procedures (Click here).