Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1516    Torque Sensor Zero Point Adjustment Incomplete

for Preparation Click here


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been completed normally.

DTC No.
DTC Detection Condition
Procedure
C1516
Torque sensor zero point calibration has not been completed normally due to touching the steering wheel during calibration.
There is no malfunction if this DTC is not output again after clearing the DTCs, initializing the zero point calibration signal, and performing zero point calibration.

INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


Go to step 3

2.PERFORM ZERO POINT CALIBRATION OF TORQUE SENSOR
  1. Perform the torque sensor zero point calibration (Click here).


NEXT


3.RECONFIRM DTC
  1. Check for DTCs.
    Result 
    Result
    Proceed to
    DTCs are still output even after performing torque sensor zero point calibration 3 times.
    A
    DTCs are still output even after performing torque sensor zero point calibration once or twice.
    B
    Normal system code is output.
    C

    HINT:
    Replace the steering column assembly if DTCs are still output even after performing the torque sensor zero point calibration 3 times.



B
Go to step 2

C
END
A

REPLACE STEERING COLUMN ASSEMBLY